Impregnating process due to no residual wash in the thread hole infiltration agent after curing the thread jams, usually we use the tapping solution, but tapping thread damage, you cannot pass through, so almost scrapped.

Our solution is to use impregnation agents in addition to agents

Soak for a few minutes, then wash, air gun, clean

Impregnating agent after curing of thermosetting plastics, if residue in screw holes, in general there is no way except, we experienced many years of development, we have successfully developed a very easy to remove curing impregnating agent cleaning agent.

Use method

Direct Immersion: when the operation is simple and convenient to use this agent into the container, and then can add five centimeters of water in the Remover the cover, as the cover for fire and volatile. Needs to be removed-dipped rubber casting into the Remover, owing to the different thickness of adhesive layer, a few minutes or a few tens of minutes, automatically all the adhesive layer removal. Rinse with water after removal. After the agent is used, filter, take off the filter NET impregnant may continue to be used more than once.

Matters needing attention

1 , The agent for solvent, volatile, and skin irritation. In order to avoid inhalation and contact with skin, operation should be ventilation and wear protective gloves and protective masks.

2 , Used when contact with skin, wash immediately with plenty of water and SOAP. If you have not rushed to the hospital.

3 , This agent has certain corrosive action to protect their own safety

Beforehand how to tackle infiltration agent residue problems please use our cleaning equipment as shown below: